[Trouble Shooting] TD2000 External TPMS
TD2000 External TPMS Trouble Shooting
1. Indications disappear from / do not appear in the display.
A. Please make sure if power switch is on.
B. Please make sure if monitor has battery inserted.
C. Be sure the power of battery is enough.
D. Be sure to observe the correct polarity when installing the batteries.
E. If you use power cord, make sure if it is disconnected.
F. Please make sure if battery has no power after use for a long time. Battery
could run out of power and we suggest replacing with new battery.
G. Please make sure if the system is in ‘sleeping mode’ as the ‘sleeping mode’ will
be triggered when system has been in idle for more than 10 minutes. It is for
power-saving purpose. You can let system back to work by shocking monitor
slightly or by pressing any of buttons in monitor.
H. If these solutions do not help improving the situation, consult your nearest
TYREDOG dealer.
2. No connection between relay(s) and monitor. The status will show as chart below.
Here we take trailer relay for example, you can find all tire pressure values in trailer
are gone (in 3 dash ---).
Take trailer relay for example
A. Please make sure if relay is in a configured distance. Even through its connection
distance can be as long as 50 meters, some interference between relay and
monitor could affect its effective range.
B. Please make sure if relay has battery inserted.
C. Be sure to sensor the correct polarity when installing the batteries.
D. Battery has no power after use for a long time. Battery could run out of power
and we suggest to replace with new battery.
E. Please make sure if your sensor has mixed with other systems’. As each sensor
has its unique identified number and monitor can only receive pre-loaded
identified number and cannot accept other new identified number.
F. If you use the function of ‘set car type’ but don’t set another new relay
identified number, you will lose original relay identified numbers and has no
connection to relay(s).
G. If these solutions do not help improve the situation, consult your nearest
Tyredog dealer.
3. No connection to any of sensors.
Take F1 (front left) tire for example
A. Please make sure if sensors is screwed on where it should be.
B. Please make sure if sensor has battery inserted.
C. Battery has no power after use for a long time. Battery could run out of power
and we suggest to replacing with new battery.
D. Please make sure if your sensor has mixed with other systems’. As each sensor
has its unique identified number and monitor can only receive pre-loaded
identified number in each tire position.
4. Monitor cannot stop beep.
When battery-lower indicator is on and keeps on running system for days straight,
it could make monitor abnormal and keep on beeping. Just change battery for back
to normal operation.
4. Monitor display color is getting dark.
When car temperature is over 85℃, it is natural that LCD panel will be getting dark.
When car temperature is back to normal, LCD panel will be normal as well。
5. When temperature is below -25℃, the response time could be slower in LCD
monitor.
6. Monitor in the ‘sleeping mode’.
Temporarily park car or drive car in a stable speed, which could let monitor get into
‘sleeping mode’. It is a special design for power-saving purpose. You can simply
slightly shock monitor or press any of buttons to wake it up.
7. Please make sure the surface of glass is clean and flat to give the best fitness to
monitor bracket. Otherwise, the monitor could drop off.
8. Tire pressure will be always changing by many environmental factors.
One of key factors is tire temperature:
Tire pressure will raise 4 PSI by about 10 ℃ temperature rise when in the room
temperature of 25℃.
9. This product is only one-year warranty.
